TAHI SATINJET SHOWER SYSTEMINSTALLATION GUIDETECHNICAL SPECIFICATIONSOperating Pressure:Min 1.5 bar, Max 5 bar. If supply exceeds 5 bar, a pressurelim
16 17 18Place footrest and mark holes. Drill clearance in lining and pre-drill supportSet footrest aside, drill clearance into lining then pre-drill s
Clean filter baskets periodicallyDo not use any sharp objects to clean nozzlesWater contains lime which remains on the surface after the water has evap
Methven warrants this product against manufacturing defects and that it is suitable for use under the operating conditions specified in this instructio
Separate footrest coverOverhead showerassemblySeparate overhead shower spacerFoam sealOverhead shower arm coverSeparate overhead shower coverRail top
Rail ShowerShower System and Overhead Shower Fastening Zone– load-bearingsupport requiredFastening Zone– load-bearingsupport required380mm360mmHoleØ25
Ensure the deeper precision bored end connects to the overhead arm of shower. This forms a watertight seal with the ‘O’ ring on the shower arm as per
Slip spacer under bracketFit foam seal around connection bar. Insert waterway and loosely screw nut on to barSlip top rail bracket under overhead show
Swing aside. Drill clearance into lining then pre-drill supportSeal hole and drive in screw (and wall plug if appropriate)Seal holes and drive in scre
10 11 12Run water to ensure the unit is sealed, then clip on coversClip on coversPush rail and bottom rail bracket hard on to mounted top bracketEnsur
13 14 15Release lever and slide shelf (if included) and handset holder on to top of railPush rail and bracket back on to top bracket and clip on angle
Commentaires sur ces manuels